Now IPv6 works and all, but still there are some problems seen above. i flash my R7000, with the following build (DD-WRT v24-sp2 (08/15/14).
#Ipv6 dd wrt v24 sp2 how to#
Traceroute6 result directly from the traceroute6 traceroute to (2a00:1450:4009:80b::1011), 30 hops max, 16 byte packetsĢ (2a01:260:1:1::18) 27.542 ms 6.234 ms 6.441 msģ (2001:2000:3080:2ef::1) 12.109 ms 12.141 ms 11.878 Note: Firmware version used in this article is DD-WRT v24-sp2 (03/29/14) std - build 23838 Thats it If you would like to use Namecheap Dynamic DNS with Mikrotik router, you may refer to this guide. In this guide: How to install DD-WRT on your NetGear R7000 and go back to stock. I also have to use a custom startup script to add a neighbour, as otherwise IPv6 won't work through VDSL. I have set IPv6 enabled under Setup and Native IPv6 from ISP, where I set it's DNS servers and the subnet assigned to me. TX packets:188036 errors:0 dropped:0 overruns:0 carrier:0 RX packets:170967 errors:0 dropped:49 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 I am also seeing packets being dropped on eth1 eth1 Link encap:Ethernet HWaddr 00:24:A5:DA:F9:DA Unreachable default dev lo proto kernel metric -1 error -128 This is probably a case of bad setting, but I would really appreciate if someone would clarify and help me fix it.įirmware Version DD-WRT v24-sp2 (11/03/14) std - build ip -6 route showĢa01:260:XXXX::4/126 dev eth1 proto kernel metric 256Ģa01:260:XXXX:2::/64 dev br0 proto kernel metric 256Ģ000::/3 via 2a01:260:XXXX::5 dev eth1 metric 1024įe80::/64 dev eth0 proto kernel metric 256įe80::/64 dev br0 proto kernel metric 256įe80::/64 dev ath0 proto kernel metric 256įe80::/64 dev eth1 proto kernel metric 256
0 kommentar(er)
